Stanley Waldrup
03-11-2007, 5:10 PM
Hello All. First post here at SawMill Creek. I am getting ready to Order a LaserPro Spirt this week but would like to construct my own rotor in my machine shop. I need to know what Servo motor they are using and a few specifications. I have a new design in mind but don't want to spend the almost $1000. If all else fails I could order a motor from LaserPro.
voltage?
is it 7 wires like Epilog?
measurement of degree per step?
model number?
Wiring print..?
anybody else built one?
Thanks
Stan
voltage?
is it 7 wires like Epilog?
measurement of degree per step?
model number?
Wiring print..?
anybody else built one?
Thanks
Stan