View Full Version : JessEm miter gauge
Tim Wagner
03-11-2007, 12:31 PM
Is the jessEm Mite-R-Excel a Good one to use on the TS? Others
Jim Thiel
03-11-2007, 12:54 PM
Hey Tim, take a look through this past post. Lots of good information and opinions.
regards, Jim
Miter gauge poll (http://www.sawmillcreek.org/showthread.php?t=32674&highlight=miter+gauge)
Tim Wagner
03-11-2007, 1:33 PM
thanks jim.
Barry Anderson
03-11-2007, 9:40 PM
I've both the Jess-m and the Jointech Smartmiter. I find myself using the Jess-M most of the time. It is easier to take on/off the table and is SUPER accurate. It is extremely heavly made. I was going to buy an Incra, but after seeing the Jess-M, I had to get one. I've never been unhappy with my purchase.
Barry in WV
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.