HF discounts

[Al Killian]

Does anyone have a coupon for HF? I am looking at buying there dovetail jig, which is not my first choice. I need a jig and money is really tight, say about $50 bucks. I have treid fleabay, but there are no good deals to be found.

[glenn bradley]

Till 3/12/07 - - -

[Dave Sweeney]

I don't have a coupon to pass along but if you print this (http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=34102) and take it to your local HF they will match the price.

EDIT: With glenn's coupon and the printout I linked you to your price is now under $23.00.:cool:

[Bruce Benjamin]

http://www.ncwoodworker.net/pp/data/500/medium/img003.jpg

[Craig D Peltier]

Is the HF jig used here by anyone? Wondering if I want to get just to see.
Thanks

I don't have a coupon to pass along but if you print this (http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=34102) and take it to your local HF they will match the price.

EDIT: With glenn's coupon and the printout I linked you to your price is now under $23.00.:cool:

[Justin Henry]

I've used 4 of the printed 30% off in last 3 days. They scan fine at the register no matter what size I used and they sure don't seem to care if you use one,walk to car and unload and then walk back and repeat it.

Only 6 more days to take advantage of what I bet they never repeat. 30% off had never been seen until this gem showed up:D

[Wes Bischel]

I've used it for several drawers (poplar as stock). They are for my 5 year old, so they needed to be durable more than beautiful. I need to adjust it a bit more for a tighter fit, but for a first try, not too bad. (yes, I know they are not the best - my issues with set-up, not the jig.) They will never be as nice as fine hand cut dovetails, but the jig works. The drawers have been holding up for a year and a half with no issues.

FWIW,

Wes

[Robert Malone]

I used the 30% off coupon printed on full page with no problem wednesday.

[Craig D Peltier]

Thanks, i went yesterday but they didnt have any. Bought a 6" benchtop grinder instead for like 25 after discount.

I've used it for several drawers (poplar as stock). They are for my 5 year old, so they needed to be durable more than beautiful. I need to adjust it a bit more for a tighter fit, but for a first try, not too bad. (yes, I know they are not the best - my issues with set-up, not the jig.) They will never be as nice as fine hand cut dovetails, but the jig works. The drawers have been holding up for a year and a half with no issues.

FWIW,

Wes