Lou Morrissette
03-04-2007, 5:37 PM
I asked around a while back if anybody had used a Grizzly H7316 band saw riser block on a Ridgid 14" band saw. Several people responded and said it was a good match. I purchased the kit from Grizzly and there was a problem. The shaft that attaches the blade guides and adjusts the cutting height on the Grizzly is .750 diameter. Unfortunately, the shaft on the Ridgid is .875 diameter. I called Grizzly tech reps and they said that was the only shaft that they provide.
Have any of you run into this situation? I figured I could have a bushing machined to accomodate the smaller Grizzly shaft or have a .875 shaft
machined. I'm open to any suggestions that will get me back into business. TIA
Lou
Have any of you run into this situation? I figured I could have a bushing machined to accomodate the smaller Grizzly shaft or have a .875 shaft
machined. I'm open to any suggestions that will get me back into business. TIA
Lou