Joe Trotter
03-02-2007, 3:29 PM
Hi guy's it's me again. I have been busy putting my tractor back together and have not had time to stop in.
I found a 10" table saw made by sprunger brothers in the sixties. I hope to take a look at it tomorrow.
It is a 2 HP motor, and cast iron table. You guys have suggested to get cast iron and higher HP so that is what I have been digging for.
Does anyone have one? I searched this forum and OWWM and did not find much.
Any help is appreciated,
Thanks, Joe
I found a 10" table saw made by sprunger brothers in the sixties. I hope to take a look at it tomorrow.
It is a 2 HP motor, and cast iron table. You guys have suggested to get cast iron and higher HP so that is what I have been digging for.
Does anyone have one? I searched this forum and OWWM and did not find much.
Any help is appreciated,
Thanks, Joe