Rob Will
02-22-2007, 10:34 PM
Here's a project that I welded up a few days ago and put together today.
It is a rolling shop table made from 2 x 2 x 1/4" angle iron.
The dimensions are 48" wide x 72 long x 34.5 high
(the same height as my table saw:) )
The 3/4" plywood tops shown here will get laminate and possibly a vinyl t-molding around the edges.
Aside from duties as an outfeed table, it will be for storage and extra assembly space.
The 8" casters (they were free) roll a little too easy so some sort of parking brake is in order.
Note that the casers are mounted on a hidden plate (channel) and set back from the outer corners by about 4". This keeps the 8" wheels out of my toe space.
Any suggestions on how to install a brake or otherwise add to this shop table?
Rob
It is a rolling shop table made from 2 x 2 x 1/4" angle iron.
The dimensions are 48" wide x 72 long x 34.5 high
(the same height as my table saw:) )
The 3/4" plywood tops shown here will get laminate and possibly a vinyl t-molding around the edges.
Aside from duties as an outfeed table, it will be for storage and extra assembly space.
The 8" casters (they were free) roll a little too easy so some sort of parking brake is in order.
Note that the casers are mounted on a hidden plate (channel) and set back from the outer corners by about 4". This keeps the 8" wheels out of my toe space.
Any suggestions on how to install a brake or otherwise add to this shop table?
Rob