Kreg (K3?) settings

[Jeff Caskie]

What settings (stop collar and jig) do people use for 3/4 plywood. If I use the 3/4 settings.. and the proper stop collar setting for 3/4, the screw does not exit the center of the ply. In addition, using the recommended 1 1/4 screw with these settings will allow the screw to 'almost' pop out the other end. Presumably, this is because 3/4 ply is not really 3/4 in width. So, that being said... what 'modified' settings do you use for plywood?

[Al Willits]

I like mind to have the drill bit point to come out the bottom just enough to see it, you can adjust the jig to do that.

Not sure if that's what you wanted though.

Al