Jack Ganssle
02-19-2007, 1:37 PM
Folks,
I'm working on an 18" diameter end-table top, and want to have a slight lip around the edge, so plan to route about 1/16" from the entire top except the rim. I'll rotate, using a jig, over the router on the router table. What's the best bit to get a nice flat cut? Would it be a hinge mortiser?
Thanks much,
Jack
I'm working on an 18" diameter end-table top, and want to have a slight lip around the edge, so plan to route about 1/16" from the entire top except the rim. I'll rotate, using a jig, over the router on the router table. What's the best bit to get a nice flat cut? Would it be a hinge mortiser?
Thanks much,
Jack