Drew Tomchick
02-02-2007, 2:22 PM
Hi, I've just switched computers, and had to reinstall all my software.
When the switch was complete I tried to test our engraver.
It seems to be leaving a pattern of dots inside the lines to be engraved.
Here is a pic since I'm not sure I am explaining this clearly.
http://www.fireballmountain.com/images/SamplePic02.jpg
Sorry its so large.
I am using a laserpro venus and coral draw 7. I'm sure its just a setting but I've tried everything I can think of.
Thanks.
When the switch was complete I tried to test our engraver.
It seems to be leaving a pattern of dots inside the lines to be engraved.
Here is a pic since I'm not sure I am explaining this clearly.
http://www.fireballmountain.com/images/SamplePic02.jpg
Sorry its so large.
I am using a laserpro venus and coral draw 7. I'm sure its just a setting but I've tried everything I can think of.
Thanks.