Glen Blanchard
01-30-2007, 9:36 AM
I have a Jointech digital router lift on my table and have always zeroed out the router bit by moving a small piece of stock above the bit as I slowly raised it. Once I could feel the bit kiss the wood, I zeroed out the readout on the lift. This worked alright, but I had variances that were greater than I had wished. I had in the back of my mind a little system that would sense electrical contact between the router bit and a flat metal object placed above the bit. I finally put it together. This is what I did.
I attached a wire to a bolt on my router lift (below the table) that I had confirmed made electrical contact with the router bit. I have another wire attached to the side of the table within easy reach – has about 12” free. I placed an alligator clip on the end of this wire. This lead runs through a hole in the side of the table and in continuous with the wire connected to the lift. In line, I have placed a battery and a cheap DC buzzer. You can figure out the rest. Since I don’t use my Forrest blade stabilizer (and I know it is flat) I place it over the bit, flush on the table, connect the alligator clip to it, and slowly raise the bit until the buzzer sounds. Works great, and is repeatable to less than .001”.
Thought I’d share.
I attached a wire to a bolt on my router lift (below the table) that I had confirmed made electrical contact with the router bit. I have another wire attached to the side of the table within easy reach – has about 12” free. I placed an alligator clip on the end of this wire. This lead runs through a hole in the side of the table and in continuous with the wire connected to the lift. In line, I have placed a battery and a cheap DC buzzer. You can figure out the rest. Since I don’t use my Forrest blade stabilizer (and I know it is flat) I place it over the bit, flush on the table, connect the alligator clip to it, and slowly raise the bit until the buzzer sounds. Works great, and is repeatable to less than .001”.
Thought I’d share.