Chris Jenkins
01-19-2007, 10:24 AM
OK, I'm getting sick of dragging my DC around and would like to install some ducting. In the last shop my DC was in the center of the room and didn't require it. Here I have it shoved in the corner and when it is in the center of the room it is always in the way.
Either way. Here is the question:
What Fittings fit what? I am using mostly 6" and some 4" reducers
Do HVAC fittings snug into (or over) S&D pipe?
And Does 6" PVC fittings make a snug fit over S&D?
This way I can run a combo of all the fittings I need. I'd like to run HVAC as it is cheaper, but the only 6" WYE's I can find are the PVC and they do NOT fit even close, unless I wrap the fittings in like an 1/8" of duct tape.
By me 5' of 6" HVAC goes about $7, 10' of 6" S&D goes for $24 and 6" PVC Wyes go for $15.
Either way. Here is the question:
What Fittings fit what? I am using mostly 6" and some 4" reducers
Do HVAC fittings snug into (or over) S&D pipe?
And Does 6" PVC fittings make a snug fit over S&D?
This way I can run a combo of all the fittings I need. I'd like to run HVAC as it is cheaper, but the only 6" WYE's I can find are the PVC and they do NOT fit even close, unless I wrap the fittings in like an 1/8" of duct tape.
By me 5' of 6" HVAC goes about $7, 10' of 6" S&D goes for $24 and 6" PVC Wyes go for $15.