Help finding plan

[Jay Knoll]

Hi

Awhile ago I saw a plan for a rolling shop tool stand in a magazine -- but of course I can't remember which one (other than I'm certain it wasn't Fine Woodworking) It was about 6' long and incorporated a spot for a chop saw, planer, it had a downdraft table and a router setup. To top things off, there were slots for clamps so you could use it as an assembly table.

I've been on Google for about 45 min to no avail.

Does this ring a bell wtih anyone? Know where I can find the plan?

Thanks for your help!

Jay

[Jim Becker]

American Woodworker had something like you describe in the past few years. The top was reconfigurable as you describe and slotted for clamping. I don't recall the issue number, however, and I'm not where I can look it up.

[Jay Knoll]

American Woodworker had something like you describe in the past few years. The top was reconfigurable as you describe and slotted for clamping. I don't recall the issue number, however, and I'm not where I can look it up.
Jim

Thanks for the lead, I hit their web site, couldn't find anything. I'll keep looking

Jay

[Jim Becker]

Thanks for the lead, I hit their web site, couldn't find anything. I'll keep looking

#82 October 2000 American Woodworker "Ultimate Tool Stand" page 48