Rob Will
01-08-2007, 3:04 AM
If you have a bandsaw (Moak 36) with a blade speed of just over 8000 fpm, what would be a good blade selection for wide resawing in cherry?
When a particular saw's speed is on the high side, does that change the blade requirements?
For example: Do high speed saws perform better with fewer TPI blades or does this make any difference?
Thanks,
Rob
When a particular saw's speed is on the high side, does that change the blade requirements?
For example: Do high speed saws perform better with fewer TPI blades or does this make any difference?
Thanks,
Rob