Bob Huddleston
12-27-2006, 5:31 PM
Hi all:
I am making a plant stand for my mom and dad, using ash. I have a template and am using a flush trim router bit with a rolling bushing guide. Here is my problem: when going with the grain, I am getting chunks blowing off the piece, so much so that I have had to give up on two pieces so far. I trimmed as close as I could with my bandsaw befor routering on my table. It is a new router bit that I bought expressly for this project.
Any ideas or suggestions on what am I doing wrong? Thanks for the ideas.
I am making a plant stand for my mom and dad, using ash. I have a template and am using a flush trim router bit with a rolling bushing guide. Here is my problem: when going with the grain, I am getting chunks blowing off the piece, so much so that I have had to give up on two pieces so far. I trimmed as close as I could with my bandsaw befor routering on my table. It is a new router bit that I bought expressly for this project.
Any ideas or suggestions on what am I doing wrong? Thanks for the ideas.