View Full Version : New DC piping and CMS bench in the shop...
Kelly C. Hanna
12-24-2006, 11:00 AM
What started out to be a simple addition of two tools turned out to be a pretty good sized shop redo this week. I finished my last job of the year last Wednesday and well, idle time is shop time right?
Read and see here...
http://www.hannawoodworks.com/CMSandDC.html
Jim Becker
12-24-2006, 1:15 PM
Looks nice, Kelly.
Oh, be very careful with a floor sweep without a cyclone...remember, anything you pick up is going to be wacked around with the metal impeller in your DC. Metal on metal if you pick up a nail is now a good thing.
Brian Clevenger
12-25-2006, 3:39 AM
Looking sharp Kelly!
I wouldn't normally be up, but I had "Santa Clause" duties.
I'll stop by one day next week.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.