View Full Version : Inlace question posted on the general board
Joe Pack
12-06-2006, 11:00 PM
I know turners often use Inlace or similar products. I need something similar to disguise a mistake on a flatwork project, but have never used this product. Any advice on the pros/cons/suitability of Inlace?
Details are posted on the general woodworking page.
Thanks.
Joe
Glenn Hodges
12-07-2006, 12:57 PM
Joe inlace will work on flat work. I used it on some wormy boards when I built a couple of lazy susans. It is easier to use on flat surfaces because it will not run. Inlace is a thick liquid. Good luck with it.
John Timberlake
12-07-2006, 1:30 PM
Joe,
You can also use epoxy or cyanoacrylate glue to mix with the Inlace granuals or wood chips. I have used cyanoacrylate (medium thickness) and wood chips to make it look like a section of burl in the wood.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.