Table saw cove cuts

[Scott Patterson]

Check this site out:

http://dknudson.unixcab.org:80/covecut.html (http://dknudson.unixcab.org/covecut.html)

helps determine fence angle for cutting coves on t/s

Regards,
Scott

[Mike Henderson]

Another one here (http://www.taunton.com/finewoodworking/pages/nmw030_pop.asp). My experience with cutting coves is that it's easier to just draw the cove on the end of your wood and then adjust things until you get the right cut. Most of the time, you're only looking for a decorative effect so if you're off a bit it doesn't matter.

Mike