Drill press auxillary table

[jonathan snyder]

Hi Folks,

I posted some pics a while back of an 1973 Delta/Rockwell drill press. I was looking for advise on removing the chuck, hoping to take care of a bad run-out problem. Delta send me a users manual, and the chuck came off with a dead-blow hammer and a stick of hard maple. The chuck was damaged, two jaws were very loose. I popped a new chuck on there and reduced run-out to .003 (.015 with old chuck), replaced the 33 year old Rockwell belt, adjusted the pulleys into the same plane, and it runs really well. I built an auxiliary table, 28"X20", added a replaceable insert and made some hold-downs and a fence. I thought you might like to look!

51317

51318

Jonathan

[Rennie Heuer]

I built an auxiliary table, 28"X20", added a replaceable insert and made some hold-downs and a fence. I thought you might like to look!


Nicely done! This is a project I've been considering ever since my new DP arrived last summer. Mind if I steal some of your ideas? :eek: :)

[Larry Fox]

wow - very nice piece. I am with Rennie, this one has been on my list for a while now.

[Jim Becker]

Very nice. It's similar to the one I have on my 'press and really makes the machine more "woodworking" friendly.

[jonathan snyder]

Rennie,
I dont mind if you steal some ideas, There is not an original idea there, I stole tham all too!!!

Jonathan

[glenn bradley]

Lookin' good Jonathon. I added a DP table right after I got my DP. What a difference in ease of use for the woodworker. I don't see how folks get along without. Well done.

[Richard Kagen]

I did my DP table a couple of years ago and have been happy with the design. My table is wide, but not very deep so I can get close to the action. Here are some of my thoughts:

1) I used three tracks while allows me to have a movable fence straight across, yet also use the screw down clamps (rockler) at angles. If you cut the perpedicular track a bit short the toilet bolt can be angled into the track when you want it. For a fence I use a piece of MDF with 2 knobs.

2) I mounted a cheap cross reference vice on a hunk of MDF and use the clamps at right angles to hold it when I want it.

3) For removable plates under the drill bit, if you mount them off center, you can rotate them and get 4 fresh back ups per plate.

4) I made a series of plates that fit over my drum sander attachments and rotary microplaner. By moving the quill, I can use the whole drum and get sanding surface below the table to edge sand

5) The whole thing is built as a box with a dust collect port on the side for edge sanding. Works great.

Anyway some ideas from my table.

[jonathan snyder]

Richard,
I wish I would have had the good fortune to see your table before I built mine! Having the short piece of track perpendicular to the other two pieces probably makes more sense, than having it parallel like I did. Offsetting the insert is a great idea, I wish I had thought of it!

Jonathan

[glenn bradley]

Item 3 is one of those "eureka" moments for me. I would of never thought of it. But now that you share it, it seems so obvious. Many thanks. I'm going to factor that in to my next table (that would be me, dreaming of a new DP).

[Dan Forman]

For item #3, you can also make this circular, and rotate just a tad for many fresh backups per plate.

Dan