Samuel Brooks
11-19-2006, 9:37 AM
I am planing in tracing the template and cutting it out of the piece of wood under it. The wood is Rift Sawn, I then used the bandsaw and turned it into a bookmatch to get my width. Total Size 12" by 12".
I need to attach it to the Alter in the background. The side of the alter is Oak Plywood. I am concerned about wood movement of the design since it's 12" x 12". I could just glue it to in a single line vertically but how would I keep it from lifting on the sides? The thickness is around 1/4" so I do not see how I could use a screw from the back because there would not be much wood for the screen to make contact with.
I also attached a picture of the whole altar.
Your thoughs will be appreciated.
Sam Brooks
I need to attach it to the Alter in the background. The side of the alter is Oak Plywood. I am concerned about wood movement of the design since it's 12" x 12". I could just glue it to in a single line vertically but how would I keep it from lifting on the sides? The thickness is around 1/4" so I do not see how I could use a screw from the back because there would not be much wood for the screen to make contact with.
I also attached a picture of the whole altar.
Your thoughs will be appreciated.
Sam Brooks