manual request

[Paul Wood]

I guess this is a request for some help plus a major GLOAT
A friend of mine called me last week and asked if I could use an old table saw. Never turning down a free tool ( I'm a tool junkie) I said sure. when I went over to pick it up, to my surprise, and delight it was an old Rockwell Unisaw 34-450. It had a 550v 3phase 3 hp motor (no good to me I can only use 220 1 phase, but another buddy repairs and rewinds motors he manage to get me a 220v 3hp Leeson motor for $200 cdn. another friend in the woodworking industry let me have a uni-fence also for $200. This saw is in amazing condition tweeked the setup a little and the cut is as accurate as my General 350. Now the request, does any one have a pdf file of or know were I can get a manual for this saw. I got a parts list from Ace Tool Repair website but I would really like a copy of the manual
Thanks Paul

[JayStPeter]

Try Delta. They sent me a manual for my 60s Rockwell jointer for free.

[Charles McKinley]

Hi Paul,

Great score!

Try www.OWWM.com They might have one you can print off.

Good luck,

[Wes Bischel]

Paul,

I was checking OWWM

Try this

http://files.owwm.com/PDF/Delta/1969-PM1501.pdf

I'm not sure if it's the same model, but close!

Wes

[Paul Wood]

The one at OWWM was perfect. THe saw was missing the dust door. I phone Delta today and got sticker shock $189 cnd for the door, I guess I will make my own from 1/2" MDF
Again thanks for the timely help
Regards
Paul

[Jim DeLaney]

I phone Delta today and got sticker shock $189 cnd for the door, I guess I will make my own from 1/2" MDF



Check Grizzley. The one for a G1023 may fit, and Griz has very reasonable prices.