John Eugster
11-09-2006, 11:59 PM
I finally replaced my 12" Delta benchtop after 12 years and am pleased with the limited use so far with the Powermatic. Being a computer resistant, hands on type of guy I'm a little confused (maybe more than a little!) about the digital read out. Can anyone offer some advice? No problem setting it once I run a piece through and mic it, the confusion I have is which button do you push so that further table movement is relative to that setting? Sometimes it seems correct but then something happens and it's way off! Then, do you need to reset the read out to zero every time? Since I build one of a kind pieces it's not in full time use. Any help would be appreciated, John