Pete Simmons
10-31-2006, 2:07 PM
For a craft show table help me make the joint for the following:
1. Lay a piece of 1/16 plywood on the table with one edge flush with front of table.
2. Fasten ( Here is the joint/glue question ) a similar piece of thin wood 1/16 - 1/1/8 90 degrees to the first sheet down off the front of the table.
3. Insert magnets in decending piece.
4. Cover table and thin ply with nice cloth ( Thats why it it thin )
5. Attach a light weight logo engraved piece of wood with steel washers in it to the magnets.
My question is ???
How to make the 90 degree joint so it does not protrude alot out over the table?
1. Lay a piece of 1/16 plywood on the table with one edge flush with front of table.
2. Fasten ( Here is the joint/glue question ) a similar piece of thin wood 1/16 - 1/1/8 90 degrees to the first sheet down off the front of the table.
3. Insert magnets in decending piece.
4. Cover table and thin ply with nice cloth ( Thats why it it thin )
5. Attach a light weight logo engraved piece of wood with steel washers in it to the magnets.
My question is ???
How to make the 90 degree joint so it does not protrude alot out over the table?