Raised panel bit set up?

[Deck Reagan]

Hi,
I have been woodworking for a while now but have never used raised panel construction.
This week I picked up a set of raised panel bits. Very basic 3 bit set to get started. Where can I find good directions on how to set up the first time and make set up stock for the next time?
Thanks,
Deck

[glenn bradley]

This is the only method I've used but, it works perfectly.

http://www.newwoodworker.com/ralstilbitset.html

[Mike Canaris]

First of all you wil need a router table...and preferably a router with speed control..try going here. (http://www.woodshopdemos.com/smfld-6.htm)

[Rick Cabot]

I think you will find their router bit instruction manual helpful. Download the entire manual or the specific bit you are working with.
http://http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/instruct.html

Rick Cabot
Dover-Foxcroft, Maine

[Rick Cabot]

Deck
The link above is abreviated (?too long) and will not work. Go to the MCLS website: http://www.mlcswoodworking.com At the bottom of the page you will see the instruction tab and you should be directed to the instruction manual.
Regards, Rick Cabot

[Deck Reagan]

Thanks guys, this is exactly what I was after.

deck