Creating Crown Molding on Table saw

[clay carr]

can someone direct me to a website or give the info for creating crown molding on a table saw. i had a website found at one time that gave details on the angle of the fence when cutting crown molding on the table saw. im sure it has come up before on this forum, a link to that thread would also be helpful. thanks.

[jeremy levine]

can someone direct me to a website or give the info for creating crown molding on a table saw. i had a website found at one time that gave details on the angle of the fence when cutting crown molding on the table saw. im sure it has come up before on this forum, a link to that thread would also be helpful. thanks.

I would just find a bit of crown molding a a lumber yard ( or Home D or lowes )
see if you can take a scrap or two. They vary 45/45 , 58/32 . Use the scraps to
set up your saw

[Nissim Avrahami]

Hi Clay

One is here
http://www.binkyswoodworking.com/CoveMouldingTip.htm

Angles chart you can find here
http://groups.google.com/group/rec.woodworking/browse_thread/thread/321f419bf40ca4a4/8b7dbbf274217784%238b7dbbf274217784

You can Google “coves on table saw”, many sites.

niki