View Full Version : Creating Crown Molding on Table saw
clay carr
10-10-2006, 3:26 PM
can someone direct me to a website or give the info for creating crown molding on a table saw. i had a website found at one time that gave details on the angle of the fence when cutting crown molding on the table saw. im sure it has come up before on this forum, a link to that thread would also be helpful. thanks.
jeremy levine
10-10-2006, 3:41 PM
can someone direct me to a website or give the info for creating crown molding on a table saw. i had a website found at one time that gave details on the angle of the fence when cutting crown molding on the table saw. im sure it has come up before on this forum, a link to that thread would also be helpful. thanks.
I would just find a bit of crown molding a a lumber yard ( or Home D or lowes )
see if you can take a scrap or two. They vary 45/45 , 58/32 . Use the scraps to
set up your saw
Nissim Avrahami
10-10-2006, 3:59 PM
Hi Clay
One is here
http://www.binkyswoodworking.com/CoveMouldingTip.htm
Angles chart you can find here
http://groups.google.com/group/rec.woodworking/browse_thread/thread/321f419bf40ca4a4/8b7dbbf274217784%238b7dbbf274217784
You can Google “coves on table saw”, many sites.
niki
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.