View Full Version : New Jointer lives!!(mini gloat)
Jerry Olexa
09-29-2006, 11:05 AM
Finally assembled the new jointer yesterday and did a few "break in" runs. Surprised by the accuracy out of the box(s). Not a lot of adjustments needed. I'm happy and anxious to get that cherry milled for the next project..pic below
Russ Massery
09-29-2006, 1:02 PM
Congrats on the jointer. Truly a must now that your buying rough stock.;)
Lars Thomas
09-29-2006, 1:02 PM
Jerry, good luck with your machine. Lars
Ken Belisle
09-29-2006, 2:08 PM
Jerry,
I picked that one up a couple of years ago and have been very satisfied. I couldn't go to an 8" like everyone always recommends, because I don't have 220v in my shop, but since I don't do much face jointing, it hasn't been a problem. I set everything when I first got it and haven't had to re-adjust anything since.
Hope you like yours as much as I do mine...........
Karl Laustrup
09-29-2006, 2:17 PM
Looking good Jerry. Like that green & gold tool in the upper left background of the pic also.
Just keep your fingers away from the spinny part. DAMHIKT!!
Karl
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.