New Jointer lives!!(mini gloat)

[Jerry Olexa]

Finally assembled the new jointer yesterday and did a few "break in" runs. Surprised by the accuracy out of the box(s). Not a lot of adjustments needed. I'm happy and anxious to get that cherry milled for the next project..pic below

[Russ Massery]

Congrats on the jointer. Truly a must now that your buying rough stock.;)

[Lars Thomas]

Jerry, good luck with your machine. Lars

[Ken Belisle]

Jerry,

I picked that one up a couple of years ago and have been very satisfied. I couldn't go to an 8" like everyone always recommends, because I don't have 220v in my shop, but since I don't do much face jointing, it hasn't been a problem. I set everything when I first got it and haven't had to re-adjust anything since.

Hope you like yours as much as I do mine...........

[Karl Laustrup]

Looking good Jerry. Like that green & gold tool in the upper left background of the pic also.

Just keep your fingers away from the spinny part. DAMHIKT!!

Karl