PDA

View Full Version : Picked up this little Gloat


Bart Leetch
09-11-2006, 10:54 PM
At Grizzly today sure makes drilling blanks easy.
Bruce Shiverdecker
09-11-2006, 11:37 PM
Looks like it work VERY Well! What are they gettin' for it?

Bruce
Martin Shupe
09-12-2006, 12:06 AM
Hey Bart, I need one of those. How much does it cost, and do you have a name or part number? Thanks!

(I always drill a little sideways in my drill press.)
Bart Leetch
09-12-2006, 1:24 AM
The Model is H7605 It costs $57.50
It is about the diameter of my Oneway Talon chuck & has 2 tommy bars & it also has a knurled ring to run it up quick before you use the tommy bars.
Martin Shupe
09-12-2006, 8:08 PM
OK, Bart, dumb question time.

I have a Jet mini lathe, with a Oneway talon (I think) chuck. Well, I am sure it is a oneway, and it is small enough to go on the mini.

Is it possible to buy jaws for the chuck I have that will hold a square piece of wood? (I guess if it was, you would have done so.)

Does oneway make a similar chuck? I have always been a little timid about buying from Grizzly, after a friend of mind had a bad experience.

Thanks for taking to time to help a relatively new turner.
Ken Fitzgerald
09-12-2006, 8:41 PM
Martin..........Go to the Oneway website. According to their instruction manual, for a Talon chuck you can get a set of #1 jaws that will go down to 3/8".