Julio Navarro
09-09-2006, 1:30 PM
(I hope its ok to post this in this section)
I want to make a couple of wye fittings for my DC duct work. Right now I am using 6" "T" fittings I got from the BORG, but I know that is not the most efficient way.
I looked into the retail ones but they looked easy enough to make my self, heck, I built the cyclone!
So I decided to do it my self.
Heres the ACAD lay out of the evolution..
46484
Heres what the layout gives me to transfer to a flat unrolled piece of galv steel duct from Lowes...
46483
Heres what it should look like when done.
46482
I printed out the layout full scale and I will be transferring that to my unrolled pipe section and then cutting it.
I'll have the pics later, I hope , if all goes well,...well, even if not, I'll post pics of the result.
I want to make a couple of wye fittings for my DC duct work. Right now I am using 6" "T" fittings I got from the BORG, but I know that is not the most efficient way.
I looked into the retail ones but they looked easy enough to make my self, heck, I built the cyclone!
So I decided to do it my self.
Heres the ACAD lay out of the evolution..
46484
Heres what the layout gives me to transfer to a flat unrolled piece of galv steel duct from Lowes...
46483
Heres what it should look like when done.
46482
I printed out the layout full scale and I will be transferring that to my unrolled pipe section and then cutting it.
I'll have the pics later, I hope , if all goes well,...well, even if not, I'll post pics of the result.