Rick Cabot
09-07-2006, 6:52 PM
Have any of the forum members had any experience with the use of the Freud CS71MAA3 Cassette 65 Molding Cutter??
The set would be used on a 3 HP 3/4" bore Delta shaper. Any input, comments or suggestions would be greatly appreciated. Thanks.
Rick Cabot
Dover-Foxcroft, Maine
The set would be used on a 3 HP 3/4" bore Delta shaper. Any input, comments or suggestions would be greatly appreciated. Thanks.
Rick Cabot
Dover-Foxcroft, Maine