Christmas Ornament

[Curt Fuller]

Hey, I think I might have even beaten Walmart at starting too early for Christmas things. But I have to 'try' to demonstrate how to turn an inside out Christmas ornament at our clubs September meeting. So I'm starting to make a few for practice. Lots of cutting, sanding, glueing, un-glueing for a 2 hr demo.

This one is made from walnut strips cut on a bandsaw from a walnut branch with a piece of grab bag mystery wood for the center spindle and finial. It's just hanging on a wire for now but will get a piece of sparkly gold thread eventually.

[Dick Parr]

Great job Curt, I bet that demo will go over big time.

Again, nice job...;)

[Bernie Weishapl]

Great job Curt. I need to make at least 3 of those for the grandkids. Demo will go over big I am sure.

[Rick Doyle]

Looks very nice, Curt! Tough to think of xmas in August, though!!:D

[Henry C. Gernhardt, III]

Nice looking work, Curt. I think your demo will go over very well with all the time, practice, and preparation you're putting into it.

[Ernie Nyvall]

I'd sure like to see that demo Curt... or maybe an article. Nice job.

[Ken Fitzgerald]

I think it's time for you to write an article Curt! Nice ornament!

[Bruce Shiverdecker]

I bow to your obvious talent, Curt! Wonderful!

Bruce

[Gary DeWitt]

Good looking ormanents! You didn't beat Costco, though. LOML reports 4 small aisles of Christmas stuff as of last weekend!