Don Baer
08-24-2006, 8:31 PM
OK so I'm in my temp shop and needed to plane 3 pieces of 8/4 24" long but since I am in a temp shop I needed some sort of a way to collect the chips. I am using my DW735 with it excellent chip extractor and have learned from previous lessons that it can generate a lot of chip and fine dust. So says I to myself, simple, Furnace filter, flex ducting, trash can and duct tape otta do the trick. I figure the fine dust might get out but with the aid of some box fans I can handle that.
So here are the results
455434554445545
It failed miserably.
Just told LOML that I'll be making a trip to HF to get there 2 HP unit and ordering the Winn 1 micron filter. This will have to do until I get the new shop and can put together a proper system. I just signed the contract today with the builder for the new shop with a house attached so I'm about 5 months away from a perminate shop.
So here are the results
455434554445545
It failed miserably.
Just told LOML that I'll be making a trip to HF to get there 2 HP unit and ordering the Winn 1 micron filter. This will have to do until I get the new shop and can put together a proper system. I just signed the contract today with the builder for the new shop with a house attached so I'm about 5 months away from a perminate shop.