Nissim Avrahami
08-24-2006, 3:16 PM
Good day
Yes I know, Festool, EZ , other methods and jigs.
This is my method and I would like to share it with you.
The ¼” strips came out very consistent, I just had to sand them.
I had one mistake; the guide is 67” long and the strips are 55”.
Regards
niki
http://i50.photobucket.com/albums/f321/avrahami/Strips/S1a.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S2.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S3.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S4.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S5.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S6.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S7.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S8.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S9.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S13.jpg
Yes I know, Festool, EZ , other methods and jigs.
This is my method and I would like to share it with you.
The ¼” strips came out very consistent, I just had to sand them.
I had one mistake; the guide is 67” long and the strips are 55”.
Regards
niki
http://i50.photobucket.com/albums/f321/avrahami/Strips/S1a.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S2.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S3.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S4.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S5.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S6.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S7.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S8.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S9.jpg
http://i50.photobucket.com/albums/f321/avrahami/Strips/S13.jpg