Cutting strips on TS

[Nissim Avrahami]

Good day

Yes I know, Festool, EZ , other methods and jigs.

This is my method and I would like to share it with you.

The ¼” strips came out very consistent, I just had to sand them.

I had one mistake; the guide is 67” long and the strips are 55”.

Regards
niki


http://i50.photobucket.com/albums/f321/avrahami/Strips/S1a.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S2.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S3.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S4.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S5.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S6.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S7.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S8.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S9.jpg


http://i50.photobucket.com/albums/f321/avrahami/Strips/S13.jpg

[Jim Becker]

Very interesting technique, Nissim! I like that "feather roller" setup, too.