Feather board, final version

[Nissim Avrahami]

Good day

Today, I made the final version (I hope), based on the second version

If you have any comment, I’ll be happy to here.

Regards
niki


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN01A.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN02A.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN03.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN04.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN05.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN06A.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN07.jpg


http://i50.photobucket.com/albums/f321/avrahami/Roller%20new/RN08.jpg

[Chris Barton]

I very much like the ingenuity of your design. What have you included to provide antikickback in your design? Are the wheels able to rotate in only one direction?

[Per Swenson]

I think thats great!

Chris is right, one way wheels.

I see patent, (for you) then big house here in the USA.


Per

[Nissim Avrahami]

Thank you so much Cris and Per

I don’t have any anti-kickback device accept the riving knife (it’s an EU tablesaw).

The rollers can rotate to both directions, but I’m sure that the rollers will not be the cause for kickback because they are detached from the board before the end of the cut (5th picture) and the last 1-3/4” are cut like you don’t use any feather board, unless there is other problem like, fence not parallel to the blade or so.

Please remember to tilt down the rollers as in the “version II” post, that way, they push the board toward the table.

niki

[Corey Hallagan]

Neat set up Niki. Looks like alot of thought went into it!

Corey

[Nissim Avrahami]

Thank you so much Corey

I think that it took me more time to make the pictures, process them and post it all.

niki