Mike Hill
08-04-2006, 12:15 PM
After finishing a new fence and table for my drill press this week, I started on a simple cabinet to hold the DP, bits and hand drills etc. Took about 8 hours, 1 1/2 sheets of ash plywood, full extension drawer glides and a quick spray of shellac. It's at the right height for me. Previously it was on my old Craftsman work bench and the bit was usually at eye level. Didn't seem safe at times :-)
This weekend I am laminating the out feed table on my table saw and will shoot some before and after pictures.
Mike
43965
43966
43967
This weekend I am laminating the out feed table on my table saw and will shoot some before and after pictures.
Mike
43965
43966
43967