Sandy Johnson
07-30-2006, 2:40 PM
Looking for experienced advice on a couple of things. First, any thoughts on a good location for a cyclone based on the attached drawing. The large white box on the rear wall of the first drawing is the approximate foot print for an oneida 3hp SDG w/55gal drum. Second, any thoughts on how to accomodate future spraying capability. I saw where someone used larger painter's tarps on the floor and 3 lightweight insulation boards to create a temp booth to contain overspray--any other suggestion (also open to placing an exhaust fan but not clear where it should be located).
Center of the room has a PM66 with a delta 3hp shaper sitting on the back side of the extension table. On the right wall are cabinets (will run cleats around the room) and a delta DJ-20. The two angled walls at the front entrance have a Rikon 18" BS and a delta 16" DP. Have to find a place for a Delta 15" planer, delta sanding center and a dewalt scroll saw on a stand. Thinking about building a SCMS center on the wall over the DJ-20 with lumber storage over that. The yellow cylinder to the left by the door is my attempt at an Ingersoll Rand garagemate compressor.
The shape of the room is fixed as the footers and block wall for the foundation are in. The contractor is about to order wood for the framing so I thought I'd try to ensure that I had a fairly good idea of a starting layout (knowing that stuff always changes). Oh, the wall height is 11.5'.
Any feedback is greatly appreciated.
43641
Center of the room has a PM66 with a delta 3hp shaper sitting on the back side of the extension table. On the right wall are cabinets (will run cleats around the room) and a delta DJ-20. The two angled walls at the front entrance have a Rikon 18" BS and a delta 16" DP. Have to find a place for a Delta 15" planer, delta sanding center and a dewalt scroll saw on a stand. Thinking about building a SCMS center on the wall over the DJ-20 with lumber storage over that. The yellow cylinder to the left by the door is my attempt at an Ingersoll Rand garagemate compressor.
The shape of the room is fixed as the footers and block wall for the foundation are in. The contractor is about to order wood for the framing so I thought I'd try to ensure that I had a fairly good idea of a starting layout (knowing that stuff always changes). Oh, the wall height is 11.5'.
Any feedback is greatly appreciated.
43641