Brian Clevenger
07-23-2006, 8:30 PM
I've had this saw for a while now, and never got around to ordering the 6" riser kit. I found out that the kit is no longer available. What other riser kits will fit this saw? I can get the JET kit at my local Rockler if it will fit. Grizzly and Delta also offer kits. I just don't know which one is a fit.
HF sells roller blade guides. Are these worthwhile, or would maple or coolblocks be better?
I just added the Rockler band saw table. I really hadn't payed these any attention, but I got an email today that said I could get one for $79. It seemed like the easiest and cheapest way to add a fence (other than the board and clamps I've been using). I'll go install it after dinner, and try to give some impressions if I get it on in time to make some test cuts. BTW, I never missed only having 6" resaw, because I only have a 6" jointer; but the Rockler table is going to take and inch away from that. A couple of things I like about the table are the larger worksurface and that it has a circle-jig built in.
HF sells roller blade guides. Are these worthwhile, or would maple or coolblocks be better?
I just added the Rockler band saw table. I really hadn't payed these any attention, but I got an email today that said I could get one for $79. It seemed like the easiest and cheapest way to add a fence (other than the board and clamps I've been using). I'll go install it after dinner, and try to give some impressions if I get it on in time to make some test cuts. BTW, I never missed only having 6" resaw, because I only have a 6" jointer; but the Rockler table is going to take and inch away from that. A couple of things I like about the table are the larger worksurface and that it has a circle-jig built in.