Jerry Crawford
07-23-2006, 4:57 PM
I just recieved my Unilift from Woodpecker and ordered a special plate for my Ryobi RE600 plunge router. The lifter installed in the table perfectly but when I tried to install my router I discovered the T-2 plate will orient (install) only in one position. That position places the ears of the plate directly over the handle points on the frame. Therefore, the rounter will not install in the lifter becaue the handles interfere with the lifting mechanism. Has anyone else had this experience and how did you resolve it? I'm not going to cut off part of the frame :mad:
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0221.jpg
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0220.jpg
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0222.jpg
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0221.jpg
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0220.jpg
http://img.photobucket.com/albums/v305/JerryCrawford/IMG_0222.jpg