Jason Simon
07-23-2006, 9:58 AM
Hi All-
I just replaced my Jet Contractor saw with a 3hp SawStop.
I bought the SawStop 36" extension table and fence.
I've started to make an assembly table, to use as an outfeed table when necessary, and part of the construction requires strips of plywood about 4" wide. I'm using the OEM SS blade, which looks to be a combo/crosscut blade with ~60 teeth.
I've noticed on the cuts that I'm getting a slight blade burn about 3/4 throught the cut. I'm thinking that the fence might either be too exactly parallel, or angles in a hair to the blade.
How do you all align your fence? Do you put it slightly out to the back?
Thanks
Jason
I just replaced my Jet Contractor saw with a 3hp SawStop.
I bought the SawStop 36" extension table and fence.
I've started to make an assembly table, to use as an outfeed table when necessary, and part of the construction requires strips of plywood about 4" wide. I'm using the OEM SS blade, which looks to be a combo/crosscut blade with ~60 teeth.
I've noticed on the cuts that I'm getting a slight blade burn about 3/4 throught the cut. I'm thinking that the fence might either be too exactly parallel, or angles in a hair to the blade.
How do you all align your fence? Do you put it slightly out to the back?
Thanks
Jason