View Full Version : Wolverine Vari-Grind Query
Jason Christenson
06-27-2006, 2:30 PM
I just got my new (used) vari-grind attachment from Amazon. I do not have the wolverine grinding jig and am wondering if anyone as tried using this attachment without it? The instructions say something about drilling a 3/8 inch hole for the stem to pivot in. Obviously I'm gonna give it a shot before I spend another 70 or 80 bucks for the jig. Anyone have any experience or advice?
Thanks in advance.
Jason
Peter Dougenik
06-27-2006, 2:42 PM
I made something along the lines of this: http://www.taunton.com/finewoodworking/pages/w00115.asp? works well and it only cost me some scrap I had around the shop!
Jason Christenson
06-27-2006, 2:45 PM
That looks great, Peter, thanks for the quick response!
Peter Dougenik
06-27-2006, 2:53 PM
no problem Jason, I remembered seeing the link on another forum yesterday so it was close at hand ;)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.