Almost done

[Rich Stewart]

A maple dish/bowl froma board end cutoff. 6 inch diameter, inch and a half high. Waterlox finish.

A little vase type thing froma piece of ash i got from John Hart. Inch and a half round. two and a half high. Just buffed.

[Bernie Weishapl]

Rich they look good. They sure look bigger in the picture. I like the vase. Nice job on both.

[Corey Hallagan]

Very nice Richard! Good looking stuff!

Corey

[Tom Sherman]

Dude are you turning these or did you get one of Curt's magic wands.;)

[Henry C. Gernhardt, III]

Rich, that's yet more great work. Is the vase completely hollowed, and if so, what tooling did you use?

[Rich Stewart]

The vase was drilled out with a forstner bit and then I semi-hollowed the bottom portion with a tool I made out of a piece of square aluminum stock from Ace Hardware with a sharpened nail sticking out of a hole in the end. I don't have the pictures on my computer anymore but if you're interested I did post them some time back. A search could probably find them. They were copys of some I saw Grumbine make.

Thank you all for the nice comments.