View Full Version : Quick lift installation
Peter Pedisich
06-22-2006, 11:04 PM
I'd like to thank Andy L. / Tony F. / Tom H. & Bill S. for your advice on a router lift.
I decided on a Woodpecker Quick-Lift in the Bench Dog plate size for my homemade router table (I cut the top on a cnc at work:D )
Hopefully I'll get some shop time this Sat. to test it out.
Pete
Richard Wolf
06-22-2006, 11:16 PM
Nice job Peter.
Richard
Corey Hallagan
06-22-2006, 11:25 PM
Good looking set up Peter!
corey
Larry Cooke
06-23-2006, 12:25 AM
(I cut the top on a cnc at work:D )Cheater! :D
Looks very nice Peter, it should sever you well.
Larry
Grant Davis
06-23-2006, 8:41 AM
Peter,
What type of fence is that?
Thanks,
Grant
Jim Becker
06-23-2006, 9:44 AM
Wow...nice machining job!
Peter Pedisich
06-23-2006, 10:33 AM
Thanks, guys.
The router table and top I made about 5 years ago in 2001. I just routed the plate recess about 1/64 deeper for the aluminum plate which was slightly thicker than the plexi plate I had in there.
Pete
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.