fingernail grinding jig size.

[Mike Vickery]

Can someone post the size of the fingernail grinding jig from the base to the pivot and from the pivot to the tool holder.

Thanks.

[Jim Ketron]

Here is my homemade version of the wolverine set up. I have made a total of 3 one for Me, Dennis Peacock and someone from another forum. I have cut off the 2 side V holders since these pics was taken, I didn't like the way they worked so off they come.
Now these are my dimensions I didn't have the original to take measurements from.
http://i20.photobucket.com/albums/b201/Jim_k/Jim%20K%20Turnings/13.jpg

[Corey Hallagan]

Mike, I measured my woverine fingernail grind jig and the measurement from the base that sits in the V holder is 4 1/2 inches to the center of the wingnut that allows it to swivel up and down. From the center of the wing nut straight up to the center of the hole that the tool goes thru is 3 inches. Hope this helps.
Corey

[Mike Vickery]

Thanks guys that is what I needed