Doug Jones
09-07-2003, 6:02 PM
I'm waiting for some online order to come in so, I can't go any further on the current project. So I took this time to make a new zero clearance insert. Then as I put the fence on top of the insert I noticed my fence wasn't square to the table. So I did the whole thing to readjust everything back to square.
Basicly this is just a reminder for all you new wood workers (as I am) to check your equipment often for proper alignment. Cause being off just a little is enough to throw your whole project out of wack.
Basicly this is just a reminder for all you new wood workers (as I am) to check your equipment often for proper alignment. Cause being off just a little is enough to throw your whole project out of wack.