Henry Cavanaugh
05-24-2006, 7:32 PM
I have just made four jewlery boxes with 3/4 splated maple set in a
walnut frame for a top. I learned that sanding the wood does not work
because of the black lines getting spread around. Using a cabinet
scrapper I got the surfaces cleaned up. There seems to still have some
wax sealer impregnated into the wood but mostly gone. I was going to
finish one with clear shellac, 1 boiled linseed oil, 1 waterlox, 1
minwax tung or 1812 the canadian tung. Any suggestions with finishing
Spalted maple is appreciated. I do have varnish and poly in the shop. I
hope that these finishes wont yellow the white background. What would
make the colored lines pop the most as well as seal from future rotting.
Henry
walnut frame for a top. I learned that sanding the wood does not work
because of the black lines getting spread around. Using a cabinet
scrapper I got the surfaces cleaned up. There seems to still have some
wax sealer impregnated into the wood but mostly gone. I was going to
finish one with clear shellac, 1 boiled linseed oil, 1 waterlox, 1
minwax tung or 1812 the canadian tung. Any suggestions with finishing
Spalted maple is appreciated. I do have varnish and poly in the shop. I
hope that these finishes wont yellow the white background. What would
make the colored lines pop the most as well as seal from future rotting.
Henry