Nissim Avrahami
05-20-2006, 10:29 AM
Good day
Yesterday, I posted some improvement to the drill stand (NOT Drill Press).
http://www.sawmillcreek.org/showthread.php?t=36723
Today I would like to share with you the way that I’m making Shelf pin holes.
The drill stand can be rotated 360* and I using this feature.
Note: instead of drilling the hole, you can rout a curve and position the drill anywhere along the curved slot, as shown on the last picture.
Regards
niki
Yesterday, I posted some improvement to the drill stand (NOT Drill Press).
http://www.sawmillcreek.org/showthread.php?t=36723
Today I would like to share with you the way that I’m making Shelf pin holes.
The drill stand can be rotated 360* and I using this feature.
Note: instead of drilling the hole, you can rout a curve and position the drill anywhere along the curved slot, as shown on the last picture.
Regards
niki