Duan Packard
05-19-2006, 1:41 PM
When your Bosh Colt spindle lock will no longer lock the spindle (when taking the bit out) you will need a 10mm open end wrench, grinder and a little time.
The wrench needs to be ground thinner and the 10mm fits the flats provided by Bosh on the spindle neatly.
The two wrench system you will end up with is actually better than the built in spindle lock which I found very difficult to use.
Duan
The wrench needs to be ground thinner and the 10mm fits the flats provided by Bosh on the spindle neatly.
The two wrench system you will end up with is actually better than the built in spindle lock which I found very difficult to use.
Duan