James Fillmore
05-18-2006, 8:57 AM
Or any info period on a honeycomb box for an Explorer 20" x 38". I bought a honeycomb box for my ULS and really like it. Been using it for 5+ years. Have to take it to the car wash once a year to get the carbon out of it or it will cause burn marks on the backs of white materials. But the support it provides is outstanding plus it allow the blower to suck the smoke out from below (there is a cut out in the back of the ULS one). Only bad was it was $1000 for the 24" x 18".
When I saw the SmartBox I hoped GCC saw the light. The vector table is very good but I would prfer the honeycomb - again a BIG one for the 20" x 38" table.
Another GREAT product (that I may make) would be a vector table that held water - only about 1/8" deep. I normally mist the surface of my vector table with water and mist both sides of the foam/rubber materials that I'm cutting to pervent any flare ups or burning. This is the only way to cut foam rubbers without burning them. I havent tried a Nitrogen flood yet. Anyone have any feedback on using Nitrogen?
When I saw the SmartBox I hoped GCC saw the light. The vector table is very good but I would prfer the honeycomb - again a BIG one for the 20" x 38" table.
Another GREAT product (that I may make) would be a vector table that held water - only about 1/8" deep. I normally mist the surface of my vector table with water and mist both sides of the foam/rubber materials that I'm cutting to pervent any flare ups or burning. This is the only way to cut foam rubbers without burning them. I havent tried a Nitrogen flood yet. Anyone have any feedback on using Nitrogen?