Josh Goldsmith
04-26-2006, 3:51 PM
Hello everybody. I am thinking about making my Craftsman 22124 table saw with biesemeyer fence from 31" right cut to 60" or so cut to the right. I can get the 2x3x.120 tube steel from a local supplier for $2.70 a ft and they sell it in 20' lengths. I only need 8' or so. Then a local powdercoating place will powder coat the entire thing for $50 or less if i prep it. Also i only need half a sheet of Melamine for to top. So basically if someone else was interested in making there table saw with more width of cut to the right we could split it.
I believe it will cost:
$54 + tax for steel
$50 or less for powdercoating
$26 for melamine 3/4" 4x8
$22 for 2- 6' 3/4 adhesive tape ruler from biesmeyer
_______________
$152 divided in half
So for $76 you can basically extend your cutting ability by a whole lot. All someone would have to do is drill a couple holes in the tube steel and build a frame for the melamine to sit on and last would be some legs to support the extension table. If someone is interested please post or pm me. Thanks Josh
I believe it will cost:
$54 + tax for steel
$50 or less for powdercoating
$26 for melamine 3/4" 4x8
$22 for 2- 6' 3/4 adhesive tape ruler from biesmeyer
_______________
$152 divided in half
So for $76 you can basically extend your cutting ability by a whole lot. All someone would have to do is drill a couple holes in the tube steel and build a frame for the melamine to sit on and last would be some legs to support the extension table. If someone is interested please post or pm me. Thanks Josh